Nice tool for the work shop
Fits my Dewalt table saw miter slots perfectly with minimal slop. Easy to use and a great device to make thin rips while protecting my fingers.
Jerry J · verified owner
Woodworking Jigs
TANYO Thin Rip Table Saw Jig
$19.99
✓ 3-pulley contact for steady feed
A thin-rip jig that rides in the miter slot and sets a repeatable strip width on the outside of the blade, so thin strips fall away safely instead of getting trapped against the fence. Three pulleys, anodised aluminium and laser scales.
Set the jig, slide the fence over until the board touches the pulleys, cut, then reset the fence. The strip falls on the open side every time.
Built for the job
3-pulley contact for steady feed
Fits the table saw's UT slot
CNC-machined anodised aluminium
Imperial and metric laser scales
Specifications
| Fits | Miter / UT slot |
|---|---|
| Material | Anodised aluminium |
| Scales | Imperial + metric |
| Bearings | 3 pulleys |
| Colour | Black |
Where it helps
Edge banding strips
Thin slats and inlays
Repeat cuts for boxes
Safer thin ripsOwner reviews
4.5 out of 5 · 78 reviews
solid and built well
seems to be what I need for thin cuts that has been a problem on table saw in past.
Sam Burrello · verified ownerWorks great with a small modification
I used this to cut 168 - 3/16 inch strips from 2x10s to make some lattice for my porch. Setup was easy and it never move on me. The 3 bearings also helped keep the board straight when sliding the fence over for the next cut. I did have to grind down the one bolt that locks the thickness adjustment, it hit on my tablesaw before tightening the gauge. I'm sure adding a couple washers would work too. This worked great for me, no complaints.
Bill S. · verified ownerTANYO jigs are CNC-machined aluminium with laser-cut scales. Tool questions go to [email protected]; orders, parcels and returns to the store where you bought.
Best seller
2-in-1
18 radii
Pro pick